shaft shoulder
英 [ʃɑːft ˈʃəʊldə(r)]
美 [ʃæft ˈʃoʊldər]
网络 轴肩
双语例句
- Numerical simulation and experimental research on open-die cold extrusion technology of electromotor shaft shoulder
电机轴台阶挤压成形的数值模拟及实验研究 - The shaft of the harpoon was projecting at an angle from the fish's shoulder and the sea was discoloring with the red of the blood from his heart.
鱼叉的柄从鱼的肩部斜截出来，海水被它心脏里流出的鲜血染红了。 - The utility model is composed of a front shaft, a rear shaft, a shaft sleeve, a shoulder fitted with a bottom sleeve, a connecting bolt, a connecting nut, etc.
由前轴，后轴，轴套，与底套配合的台肩，连接螺栓，连接螺母等构成。 - The open-die cold extrusion technique is firstly applied in forming of the multi-diameter shaft's shoulder fillet.
将开式冷挤压技术用于阶梯轴台肩圆角的成型。 - An assembly step matching the shaft shoulder of the mainshaft is positioned on the shaft sleeve and a fixed gap forms between the shaft sleeve step and the water-tight plate.
轴套上设有与主轴轴肩配置的装配台阶，轴套台阶与水密封板之间形成有固定的间隙。 - The result shows that it is the localization incompletely of shaft shoulder which causes the fracture of pin.
在综合分析断裂现象、化学成分和实际工作情况后，认为轴肩定位不完全是导致销轴断裂的主要原因。 - Research on velocity field modelling of the multi-diameter shaft's shoulder fillet forming by open-die cold extrusion
飞边槽结构形式对模锻成形的影响阶梯轴台肩圆角冷挤压成形速度场建模研究 - Finite element analysis is combined with optimum technology in this study. Software is designed to optimize shaft shoulder transition curve. An optimum shaft shoulder transition curve shape is offered, which can low stress concentration of shaft shoulder transition curve to a considerable degree.
将有限元分析与优化技术相结合，设计了轴肩过渡曲线形状优化软件，提出能在较大程度上降低轴肩过渡曲线应力集中的优化线型。 - Trials found that: the first small diameter of the friction weld using molding, large diameter shaft shoulder is more conducive to plastic flow of metal.
试验中发现：小的摩擦头直径有利用焊缝成型，大的轴肩直径更有利于金属塑性流动。 - The result shows that: dual axle shoulder friction stir welding head tensile strength can achieve the mother material of 78%, but less than single shaft shoulder joint, can achieve single shaft shoulder joint strength of 86.2%.
结果表明：双轴肩搅拌摩擦焊接头的抗拉强度可以达到母材的78%，但低于单轴肩接头，能达到单轴肩接头强度的86.2%。